Recent content by V150super

  1. V150super

    Critique Request New one from the bench

    Thank you. I agree 100%
  2. V150super

    Critique Request New one from the bench

    Hey folks, here's a new one from the bench. I'm still trying to get my inlay to where I like it. I'm pretty sure I need to dig a little deeper. Went .020" this time, but I'm thinking the magic number is around .030" for the size stone I'm using. This one is turquoise and what's supposed to be...
  3. V150super

    Critique Request Knife I did.

    Sage, I'm not sure if you've looked at them yet, but Byrd by Spyderco are well made, affordable knives that cut fairly well.
  4. V150super

    Gerber Flatiron negative relief

    Thank you!
  5. V150super

    Gerber Flatiron negative relief

    Thank you!
  6. V150super

    Gerber Flatiron negative relief

    Hey folks, I wanted to share a knife I knocked out yesterday. Cutting this soft aluminum is pretty tricky, but it's nice to be able to complete an entire project in one day.
  7. V150super

    Critique Request Just finished this.

    Looks great Sage! Looking forward to seeing more of your work in the future.
  8. V150super

    TRANSFERS

    Brother laser copier and basic nail polish remover works for me. Just make sure the part is warm and 3X clean with acetone.
  9. V150super

    What is a good printer setup for doing transfers on to metal?

    As a tattooer of many years we always had access to old thermal (Thermofax) printers. Basically they print a stencil made up of gentian violet dye that transfers to skin from a translucent paper. With tattooing you'll prep the skin first with soap or some other medium, apply the stencil, remove...
  10. V150super

    Stainless steel blanks

    Lots of great advise already. I'd also add that annealing the steel beforehand seems to help me as well, Heat it to cherry red for a minute or so and then stick it in some (fresh) kitty litter for about 10 minutes or until its cool. This helps to relax the steel and evens out the hard spots
  11. V150super

    Shading technique

    I use the Lindsay Bench Jewel. It's a pneumatic powered graver.
  12. V150super

    Shading technique

    I like to use a 120° for shading. It takes some finesse, but I like that I can taper from a hair line to a wide finish without having to go too deep.
  13. V150super

    Arizona engravers?

    Thanks everyone! I got myself set up with Jeff Parke.
  14. V150super

    Arizona engravers?

    Dan I took a look at that site, but I couldn't find anything to do with engraving. Did I miss something?
  15. V150super

    Printable drawings for practice plates

    Thank You!
See more

Latest posts

Sponsors

Top