I am truly overwhelmed by the responses on this thread. I trully thank you, as you all have given me good tips -- I came and found gold after reading your comments.
I was not also, but TBH now 90% of the time I log onto it is to read the group: https://www.facebook.com/groups/EngravingBench
As far as I understand, this is Sam's group on FB.
Thank you for the prompt reply Allan. I am currently re-watching the chapter about roman lettering as I write this. I get what you mean about the triangles perfectly described there.
Thank you for sharing your use on graver's geometry.
Hello Matthew, thank you for your reply. I bought the Lettering Techniques a while back. I remember that while being really descriptive about lettering in general for people who never tried to do so, the specific engraving process for letters in 2 mm is not there (I will re-watch later for sure)...
Hello all,
I am a fairly new member, actively participating a bit more on the FB page than here on the forum. I have a question though: can you share some tips for signing your work, specifically on the lettering?
Seems I always mess up this part as I am able to hand engrave roman letters in...