Forum: Bench Options

I bought a stainless steel ball in a Gardencenter for about 15 euro. It is Decoration, and flat on the bottom side. I drilled a big hole inside the...

One thing that would be fun is to see would be studio´s and benches from the members of this site. We have seen some examples here and there in some...

this is based on a plate by brian powley. his plate was modified by ray flick. i added my own touch to make it even more easily made with minimum...

marvin hosalak sent me this.he asked if i'd post it. cut bowling ball with hacksaw.drilled & tapped hole of proper size cut a suitable length of...

Here's what I got from Bob via email. He's been busy at work making another vertical knife fixture based on the ideas in the previous thread. What a...

The subject recently came up about how to hold a knife vertically for engraving the butt end. I'd remembered that Bob Finlay in Emporia, KS had a...

Hi All, I have a positioning vice that was reluctantly moving to center itself under the microscope. This I found truly annoying, so I did...