i am a fan of that particular revolver style. the work looks cool too. not sure if that brand of libation was conducive to quality engraving.monk 10-20-2016, 08:56 PM
i like the diy stuff myself. as long as it works, you can get the real stuff later. when posting those fotos, you should post
(include) them all in the original posting. doing it your way, takes...
Thats an invaluable pdf bartelfitzneel you should post it to the forum! Thank youThomaseason 10-20-2016, 08:28 PM
Thank you for the input bob, those bits sticking out are meant to be handles, there off now though as its easier without them, good advice on the bowl as it tends to tip steeply, thank you! I'll look...Thomaseason 10-20-2016, 08:26 PM
Ive never even heard of that site, thank you for sharing that informationThomaseason 10-20-2016, 08:21 PM
Get a drawplate, order some 18ga 24k round wire, and draw to whatever sizes you need. There is no reliable flat graver to wire size chart as flat gravers will often vary from manufacturer to...sam 10-20-2016, 07:46 PM
Sounds like you are new to inlay, MTC start with copper wire or .999 silver. Cheap and good practiceDave London 10-20-2016, 07:22 PM