Roger what size is the taper on your machine?, if it is a standard morse taper you can get the ER collet chucks in MT1, MT2, also ER collet chucks with straight shanks but not smaller than 10mm...RDP 11-27-2015, 10:57 PM
something you may not want to hear is , you may have to move. Go where the work is.Eugene Carkoski 11-27-2015, 09:17 PM
The style that Duane Graham did (and it is a very nice piece of work) would be called a 3 piece set.
For the logical reason being that there are 3 pieces involved. Or an end bar buckle with...
The one I'm planning has the bar in the back and is open in back. The last issue of The Engraver has one on page 24.tdelewis 11-27-2015, 05:23 PM