Spyderco Knife

Dennis Sprague

Elite Cafe Member
Joined
Jan 23, 2007
Messages
111
Location
Prairieville, Louisiana
Hey Guy's and Gal's
This is my latest project knife.The theme is a little different than what I would be incline to do,but it was a request from a good friend, so I gave it a wirl. Comment's, critique or question's always welcome .
Happy New Year:beerchug:
Dennis
 

Attachments

  • 100_1321.jpg
    100_1321.jpg
    99.4 KB · Views: 343

ED DELORGE

Elite Cafe Member
Joined
Nov 17, 2006
Messages
384
Location
LOUISIANA
Hello Dennis, that looks very good, I'll bet that is one of those stainless pieces that are tough to engrave?

Ed
 

ddushane

~ Elite 1000 Member ~
Joined
Jan 7, 2007
Messages
1,016
Location
Andrews, TX
Dennis, I'm not much on skulls, but you did an awesome job on it, the web is great, and the scroll work is outstanding. Thanks for showing!

Dwayne
 

Dennis Sprague

Elite Cafe Member
Joined
Jan 23, 2007
Messages
111
Location
Prairieville, Louisiana
Thanks everyone,
Your replies are much appreciated.
Ed, the spyderco byrd knive's are not to bad to cut, but do have some gummy spot's in them.The spyderco stainless is much more consistent, at least that has been the case for me.Hope to see you soon.
Scot, I would like to take a second and thank you for what you and your family do for the engraving community, I'm sure that it is hard work to plan and put on the engrave-in. Hope to make it there someday.
Happy New Year:beerchug:
Dennis
 

Latest posts

Sponsors

Top